HP SAS Hard Drives HP SAS Hard Drives HP SSD Hard Drives DELL SAS Hard Drives DELL SAS Hard Drives Hard Drives u320 Hard Drives SAS/SATA Hard Drives
Memory Controllers Processors Power Supplies
     Create Account    Your Cart    Checkout    Contact Us   
  Home : 652564-B21 Login | Create Account | Your Cart | Shipping | Contact Us  

    |   |   | 
U320 Hard DrivesU320 DrivesProliant U320 Options Solid State DrivesSolid StateSolid State Drives SAS/SATA Hard DrivesSAS DrivesProliant SAS/SATA Options SAS/SATA Hard DrivesSATA DrivesProliant SAS/SATA Options Fibre Hard DrivesFibre DrivesProliant Fibre Options MemoryMemoryProliant Memory Options ControllersControllersProliant Controllers ProcessorsProcessorsProliant Processors Power SuppliesPower SuppliesProliant Power Supplies NetworkingNetworkingNetwork Adapters
 652564-B21 HP G8 G9 300-GB 6G 10K 2.5 SAS SC replacement instructions             
FRU remove/replace: Hard Disk Drive Part# 652564-B21


652564-B21 Proliant Hard Disk Drive removal

Caution!  When replacing a hot-pluggable drive, follow these guidelines to prevent data loss:

  • Never remove more than one drive at a time (two drives if you are using Advanced Data Guarding).
  • Never remove a drive while another drive is being rebuilt.
  • If the system has an online spare drive, wait for it to complete rebuilding before replacing the failed drive.
  • If you replace a drive while the system is off, it may be necessary to rebuild the replaced drive.

Caution!  Removing more than one drive at a time can cause the enclosure to overheat. Install a drive or drive blank as soon as possible.

  1. Press the thumb latch and pull the ejector lever to the full open position.
  2. Pull the drive out of the enclosure drive bay.
  3. If installing a hard drive blank in place of the drive, insert the blank into the bay until it clicks into place.

652564-B21 Proliant Hard Disk Drive replacement

  1. If a drive blank must be removed to install a new drive, squeeze the tabs to unlock the drive blank. Continue to squeeze the tabs while sliding the drive blank out of the drive bay.
  2. When installing a replacement drive, press the thumb latch and pull the ejector lever to the full open position.
  3. Insert the drive into the bay, sliding it in completely. Make sure the ejector lever is in the full open position to ensure a correct latch.
  4. Close the ejector lever against the front of the drive until it clicks into the thumb latch.
  5. Confirm that the drive is firmly seated and that the ejector lever is latched.
  6. Caution!  Data can be lost if the drive is not firmly seated.

  7. Observe the drive status LEDs to confirm that the replacement drive is functioning properly.
CanadaPartsDirect                  Ph: 1.613.599.1287                  Fax: 1.613.599.8120
DellDell  |DellEQL  |DellEMC  |DellHP  |DellIBM  |DellSeagate  |u320 Hard DrivesU320  |Solid State DrivesSSD  |SAS/SATA Hard DrivesSAS/SATA  |Fibre Hard DrivesFibre  |MemoryMemory  |ControllersControllers  |Processors Processors  |Power SuppliesPower Supplies |NetworkingNetworking 
Home | Shopping Cart | Delivery | Forgot Password | Order By Phone | Create an Account
Terms of Use | Legal | Privacy | Primary Site | Contact us | Add to favorites